Scanner Settings
The Scanner Settings section allows you to configure the following settings:
Engine Settings - you can enable the following modes:
Fuzzy 1D processing - optimizes decoding performance on 1D barcodes, including damaged and poor quality symbols
Display Mode - improves barcode reading performance off mobile phones and electronic displays
Picklist Mode - enables picking out and decoding a barcode from a group of barcodes that are printed close together by placing the aiming pattern on the specified barcode
Feedback Profiles - select the scanner's audio feedback: Normal, Long, or Silent (disabled)
You can also enable or disable the scanner's Haptic Feedback
Sleep Mode - select the amount of idle time before your device goes into sleep mode
Show barcode content on display - disable or enable the barcode echo feature for MARK Display which displays the scanned barcode for the set amount of time
Scanned barcode duration - select for how long the barcode content displays
TX Power Attenuation - adjust the signal strength of your scanners (expressed in dBm) in order to reduce the scanner's battery power consumption. The default and maximum value of TX power is 0 dBm
Caution
TX Power Attenuation can affect the scanner's scan range. We advise you to test the feature extensively before implementing it in your work processes.
Note
TX Power Attenuation is developed for specific use cases and can significantly alter the scanner performance, and it is available upon request.
To enable this feature on your Insight Webportal account, please reach out to your ProGlove contact person.
Scanner Illumination - adjust the brightness of the scanner's LED camera flash (percentage) in order to optimize battery consumption in areas of good lighting
Note
Scanner Illumination is developed for specific use cases and can significantly alter the scanner performance, and it is available upon request.
To enable this feature on your Insight Webportal account, please reach out to your ProGlove contact person.
Beacon signal - enable emitting of the beacon signal from your scanner when on the charger and register it on your Gateway device to ensure it is not lost.
Out of range - set your scanners to alert their users when out of range from the defined network. To enable the feature, select at least one Alert type (noise or vibration) and then the time in which you want the feedback to repeat. The default setting is 5seconds.
