LED feedback
The Power (first) LED light on your Gateway Plus will glow green as long as the device is connected to the power source. The table below lists the behavior of other three LED lights (Data, Scanner, Cloud) in specific situations:
Description | Data (LED 2) | Scanner (LED 3) | Cloud (LED 4) |
---|---|---|---|
Gateway Plus boots up (about 1 minute) | All LEDs flash alternating between blue and green until start | ||
Gateway Plus connected to target device/server for data transmission via cable (USB/RS232/Ethernet) | Constantly green | ||
Gateway Plus not connected to any scanners | Off | ||
Gateway Plus connected to one or more scanners via BLE |
| Constantly green | |
Gateway Plus connected to the maximum number of allowed scanners | Constantly yellow | ||
Gateway Plus cannot connect to another scanner but a scanner tries to connect | Flashes red 3 times | ||
Gateway Plus receives data from scanner | Flashes blue | ||
Gateway Plus sends data to host system | Flashes blue | ||
Gateway Plus USB Mass Storage activated/deactivated | All LEDs flash blue 3 times | ||
All files on Gateway Plus Mass Storage processed successfully | All LEDs flash green 3 times | ||
Failure in processing files on Gateway Plus Mass Storage | All LEDs flash red 3 times | ||
Gateway Plus firmware update in progress | All LEDs flash alternating between purple and yellow until start | ||
Gateway Plus downloading assets for Remote Updates | Flashes purple 3 times | ||
Scanner firmware update started | Flashes purple 3 times | ||
Gateway Plus searching for network | Flashes yellow | ||
Gateway Plus connected to network and searching for INSIGHT webportal | Constantly yellow | ||
Gateway Plus connected to INSIGHT | Constantly green | ||
Gateway Plus receives data from scanner or sends data to INSIGHT | Flashes blue |