Skip to main content

ProGlove Documentation

Remote Configuration

Apply configuration remotely
  1. On INSIGHT webportal, select Devices

  2. From My Organization, select the level to which you want to link and apply the configuration.

  3. After you have selected a level, open the three-dot menu next to the level name or click the More button in the top-right corner, and select Settings.

  4. Switch to the Remote Config tab and select the Configuration from the drop down menu to assign it to the selected level. In case there are no previously created configurations, you can use the button located below the menu to go directly to the Configuration tool and create one. Once you create the configuration, you will need to return to this screen to apply the configuration to the level/sublevel.

  5. Once you've completed the setup, click Apply at the bottom of the page.

  6. The configuration is then applied to the selected level, its sublevels, and all associated Connectivity devices will receive the configuration next time they become active.


  • In case Connectivity devices are linked with a hierarchy of levels with sublevels, the level most specific (or closest) to the Connectivity device overrules all other levels.

  • Only one configuration can be a applied to a level or sublevel (1:1).

  • Levels within My Organization should have a single type of Connectivity device (e.g. INSIGHT Mobile or Gateway).

  • In case you are using older configuration files created before the release of the Remote Configuration functionality make sure you edit and save them once before you are able to link them to levels and/or sublevels.

Check if the configuration was successfully applied to the level and connected devices

Prerequisite: Connectivity device has the status of Connected in the Connectivity device list

  • In the Devices list, select the Connectivity device from the list

    The Last Configuration column shows the configuration which is currently deployed on the Connectivity device and on the Scanner.